mirrow stalk

A place to discuss matters related to Honda Helix scooters.

mirrow stalk

Postby txbiker » Tue Jul 10, 2018 9:42 am

:( Can the mirror be removed from the mirror stalk ? It would make installing the 4 bolts so much easier if I could put the rubber down over the stalk after mounting the stalk. Old rubber is resisting bending enough to access the bolt holes.
Posts: 12
Joined: Wed Jan 17, 2018 8:27 pm
Location: Lancaster County, PA

Re: mirrow stalk

Postby clockman48 » Tue Jul 10, 2018 11:22 am

hi.. just reread your question and will add this...
I would not take the mirror off the ball to install bolts ....new .boots I am not sure if you can put them on from the bolt end. but if you want to remove the ball end.........
first loosen the tension screw. I removed it.

what I had to do next is at your own risk ! I used a hair dryer to warm the area where the metal ball goes into the mirror, but not too much as to melt or deform it. then pull out......reverse to put on.

the heat may not be necessary but I could not pull it out cold.....
just a ball and socket
Posts: 88
Joined: Sat May 14, 2016 11:50 pm

Re: mirrow stalk

Postby charlie55 » Wed Jul 11, 2018 5:00 pm

Couple of tips:

- Try heating the boots gently with a hair dryer. That may soften them up a bit.

- Once you have the mirrors off, try spraying or brushing the boots with a silicone-based lubricant and let it soak in.
Ego equitare ergo sum
User avatar
Posts: 341
Joined: Tue Aug 18, 2009 12:45 pm
Location: New Jersey

Return to Honda Helix

Who is online

Users browsing this forum: No registered users and 4 guests