helix gas tank

A place to discuss matters related to Honda Helix scooters.

helix gas tank

Postby txbiker » Fri Jul 13, 2018 1:38 pm

I purchased a new helix/fusion gas tank and would like to hear of others experience. I dont think the fuel level sender is going to work without work on bending the float arm. Even after bending arm I am not sure the locking ring is going to work. Am I missing something about reinstalling the locking ring? The only other problem is the mounting tab holes are much smaller but can be drilled out to allow use of the rubber mounting pads from the helix.
Posts: 12
Joined: Wed Jan 17, 2018 8:27 pm
Location: Lancaster County, PA

Re: helix gas tank

Postby birdmannn101 » Sat Jul 14, 2018 2:58 am

You should not have bent the rod. Just make sure that the tab on the top of the sending unit lines up with the tab on the tank. It fits right in that little notch.
95 Helix
97 Helix
65 C102
User avatar
Posts: 167
Joined: Tue Jul 26, 2016 9:53 am
Location: Indianapolis, IN

Return to Honda Helix

Who is online

Users browsing this forum: No registered users and 3 guests